Inficon DCM-250 Deposition Control Monitor Software Manuale Utente

GETTING STARTEDDeposition Control MonitorIPN 611802 Rev. BDCM-250

SAVING AND RESTORING THE CONTROLLER SETUP The DCM-250 allows you to save and restore the complete parameter setup of the MDC-360/370 series deposition

It's a good idea to make periodic backup copies of the setup files. This will minimize the possibility of having to manually re-program the depo

COMMUNICATIONS TROUBLESHOOTING If you have any communication errors then check the following: • Make sure the Deposition Controller’s power is on. •

GETTING STARTEDDCM-250Deposition Control MonitorIPN 611802 Rev. Bwww.inficon.com [email protected] to our continuing program of product impr

TrademarksThe trademarks of the products mentioned in this manual are held by the companies that produce them.INFICON® is a trademark of INFICON Inc.A

DCM-250 SPECIFICATIONS Deposition Controller Software MDC-260/360C/361C can have any software version installed. MDC-360/361 must have a minimum of

INSTALLING THE DCM-250 The setup program should start automatically when you close the DCM-250 installation CD-ROM into your drive. If it doesn’t you

ESTABLISHING COMMUNICATIONS WITH THE DEPOSITION CONTROLLER (RS-232 OR 485*) 1. Connect your computer's serial port to the controller's seri

COMMUNICATION MODE SETTINGS The DCM-250 has three communication modes: • Simulate Mode Select this mode to run a demonstration of the DCM software.

To change the DCM-250 communication mode, select the Options item from the Process menu.